Gbc 230E MultiBind User Manual download pdf (Page 7)

Wire binding instructions

For use with GBC 21 loop wire elements.

1. Set the wire

Lift the lid and punch handle to the upright position.

Place entire document so it rests on the lid.

Check the wire size (mm) needed using the pa

per thickness

guide.

Measure your wire using the wire size guide.

2. Sort paper

For mana

ging large documents use the document

separator.

Push the separa

tor into the document.

Lift the separa

tor upwards to reveal the ﬁrst stack of paper

ready for easy punching.

3. Set paper size

Load the ﬁrst pa

per stack into the punch slot.

Centre the pa

per using the dial located at the front of the

machine.

Adjusting your machine for A5:

Slide the switch loca

ted at the front of the machine from A4

to A5.

4. Punch paper

For manual punching:

Lower the raised handle until the paper is punched and support

the machine when lifting the handle to the upright position.

For electric punching (230E only):

Press the ‘punch button’ located on the right panel of the

machine.

Note:

If the machine is overloaded and fails to complete the punch

cycle, the red LED will be lit. Press the ‘punch button’ to cancel

the red LED. If this does not work contact the service helpline.

5. Wire binding

Open the hinged cover a

t the front of the machine to reveal

the wire binding channel.

Place the wire (open side up) on the wire support.

Feed each pa

per stack onto the wire and repeat until your

document is complete.

Support the document and wire on removal from the wire

support.

Insert the document into the wire closing ja

ws (wire opening

face down).

Support the document and pull down the handle a

t the side

of the machine to close the jaws.

Use the wire closing guide (loca

ted in the wire closing jaws)

to ensure correct closure of the wire.

Binding tips:

To hide the spine of the wire:

• Load the internal sheets onto the wire ﬁrst, repeating until all

are loaded.

•

Load the front PVC cover onto the wire element.

• Load the rear cover onto the wire element last.

• It is best to close the wire a little, check, and then close the

wire a little more until you are happy with the wire closure.

• Always use the wire size closing guide (located in the wire

closing jaws) to prevent over closing the wire.

•

For further hints and tips please visit our website:

www.gbceurope.com

1 2 3 4 5 6 7 8 9 10 11 12 ... 73 74

Comments to this Manuals

No comments

Gbc 230E MultiBind User Manual Page 7

Comments to this Manuals

Related products and manuals for Equipment Gbc 230E MultiBind