Gbc 150 Creasematic User Manual

KAS

SmootherguidesSpring loaded pinBottom shaftTop shaftLower perforatingwheelUpper perforatingwheelControl wheelsControlwheelsRulePerforator unitShaft fl

Crease Matic 150 The new Crease Matic 150 is a fully programmable card creaser developed specifically for the short to medium run digital print mark

Crease Matic 150 Operation: The creasing machine has five (5) programs that are saved on power down. Each program may contain up to nine (9) crease

Crease Matic 150 Operation (continued): In ‘run’ mode the feed motor and/or crease motor may be stopped at any time by pressing any of the four keys

1) Knife DepthAdjustment BlocksKnife Driver3) Bolts for Adjustmentof LHS Lay2) Screws for Adjustmentof RHS LayLHS Lay Support BarRHS LayCrease BlockTu

1. Ensure Crease Matic is in ‘setup’ mode. Decimalpoint in last position of screen and LED off. Selectjob number to program, then press ‘crease’.2. Pu

CROSS LEFT CREASE RIGHT Power on Reset memory Sensor to crease = 16 Edit sensor to c

CROSS LEFT CREASE RIGHT Power on If ‘9999’ displayed at start up. Press to reset

1/8”(3.17mm)1/4” (6.35mm)Position of Perforating wheels when in open position Position of perforating wheels when in closed position Lowerperforatin